Changing the Head Wheel With Screw For Epson PLQ 20 Printer

Changing the Head Wheel With Screw For Epson PLQ 20 Printer requires careful handling. In addition, the head cable is crucial for transmitting signals between the printer’s control board and the print head. Below is a concise step-by-step guide to assist you with the replacement.

Turn Off and Unplug the Printer

First and foremost, ensure the printer is completely powered off and unplugged from the power source. By doing so, this action prevents electrical hazards, which is essential for your safety.

Remove the Printer Cover

Next, take off the top cover of the printer to access the internal components. Depending on your model, you might need to remove screws or use a bar to open it. This step, therefore, allows you to see the printer’s inner workings clearly.

Take Off the Ink Cartridges

With care, remove the ink cartridges to provide better access to the internal parts. Consequently, this step improves your ability to work on the head cable without obstruction.

Move the Carriage to the Center

Gently, move the carriage to the center of the printer. As a result, this action will make it easier to reach the head cable. Overall, this positioning significantly enhances your working experience.

Find the Head Cable

Now, locate the head cable that connects to the print head and routes to the control board. Identifying this cable is essential for the replacement process. Moreover, understanding its position will guide your actions.

Remove the Old Head Wheel With Screw

At the Print Head End

Carefully, take off the head cable from the print head. This step may involve gently pulling out the connector or freeing a bar, depending on how it’s fixed. As a result, you avoid damaging any surrounding components.

At the Control Board End

Next, discover where the cable connects to the control board. Specifically, remove it by pulling out the connector or releasing any clips or bars. This action, therefore, is critical for completely detaching the old cable.

Disconnect the Old Cable for new Head Wheel With Screw For Epson PLQ 20 Printer

Once both ends are removed, take off the old cable from its routing path. In addition, be sure to note how it is routed so you can install the new one in the same manner. This attention to detail, consequently, helps prevent installation issues later.

Place the New Head Wheel With Screw For Epson PLQ 20 Printer

Route the New Cable

Use the same routing path as the old cable to ensure proper placement. Additionally, confirm that it fits correctly to avoid any kinks or tangles that could impede functionality. Therefore, maintain the integrity of the cable’s path.

Install the New Head Wheel With Screw For Epson PLQ 20 Printer

To the Print Head

Connect the new cable to the print head. Make sure that it securely fixes and aligns correctly. This step is essential for ensuring proper signal transmission.

To the Control Board

Then, install the other end of the cable to the control board. Ensure that it firmly connects and sits properly. Thus, this action guarantees a solid connection for optimal performance.

Reassemble the Printer

Afterward, replace the ink cartridges you removed earlier. In addition, shut the printer cover and secure it with any screws or bars that you took off. This process, therefore, restores the printer’s integrity and prepares it for use.

Turn On the Printer

Next, plug the printer back into the power source and switch it on. This step is vital for confirming that the installation was successful.

Check the Printer for Head Wheel With Screw

Run a test print to ensure that the print head functions correctly and that no issues arise with the new cable. In this regard, this test is an effective way to verify your work.

For more troubleshooting tips, visit our blogs, and don’t forget to subscribe to our newsletter for ongoing support.