CCD Motor Old Model For HP LaserJet M1005 Printer

Steps to Replace CCD Motor Old Model For HP LaserJet M1005 Printer :

1. Power Off the Printer

   • Turn off the printer and unplug it from the electrical outlet for safety.

2. Open the Printer Cover

   • Lift the front cover to access the toner cartridge and internal components.

3. Remove the Toner Cartridge

   • Carefully pull out the toner cartridge and set it aside on a clean surface.

4. Access the Scanner Assembly

   • Depending on your model, you may need to remove the ADF (Automatic Document Feeder) if present. Use a screwdriver to remove any screws and detach the ADF.

5. Remove the Scanner Unit

   • Look for screws or clips securing the scanner unit and remove them. Carefully lift the scanner unit off the printer.

6. Locate the CCD Motor

   • Find the CCD motor, usually situated near the scanner assembly.

7. Disconnect the Wiring

   • Carefully unplug any connectors attached to the CCD motor. Take note of their positions for reassembly.

8. Remove the Old Motor

   • If the motor is secured with screws, remove them using a screwdriver. Carefully take out the old motor from its housing.

9. Install the New CCD Motor

   • Position the new CCD motor in the same location as the old one and secure it with screws.

10. Reconnect the Wiring

    • Plug in any connectors that were disconnected earlier, ensuring they are secure.

11. Reattach the Scanner Unit

    • Lower the scanner unit back into place and secure it with screws.

12. Reinstall the ADF (if removed)

    • If you removed the ADF, reattach it securely.

13. Reinstall the Toner Cartridge

    • Carefully insert the toner cartridge back into the printer.

14. Close the Printer Cover

    • Close the front cover securely.

15. Power On the Printer

    • Plug the printer back into the electrical outlet and turn it on. Allow it to initialize.

16. Test the Printer

    • Print a test page or scan a document to verify that the new CCD motor is functioning properly.